1 / 2
Legálisan kinyomtathatjuk neked
Kereskedelmi célra is kinyomtatható, ha feltüntetjük a tervezőt; a módosított tervet ugyanígy kell továbbadni.
Creative Commons Nevezd meg! – Így add tovább! (CC BY-SA) · A tervező nevét a rendelésednél is feltüntetjük.
Alkatrészek
3 / 3 kijelölveVedd ki, amelyik részre nincs szükséged. Mindegyik ugyanabból az anyagból és színből készül.
A tervező leírása
Eredeti nyelven, a Printables oldaláról.
Note: Update available here: Pocket Screwdriver Kit v2
I picked up a pocket screwdriver kit similar to this at a tradeshow many years ago, and I wanted another one so here it is. The bits fit in snugly and the cover snaps closed.
No supports required (but you might need a brim for the outer case). Print in three pieces then glue the insert and handle together using the alignment nubs. You will also want to glue a tiny magnet in end of the case to hold the bit in place when using the screwdriver.
Disc magnet for the tip should be no larger than 6mm x 1mm – thicker magnets will hold the bits too strong. E.g., https://amzn.com/dp/B01NAL9I5H/
Any straight ¼" / 6mm bits should work, up to ~ 1" / 25mm in length. E.g., https://amzn.com/dp/B09T9H1DFC/
Update:
Added extra-tolerance-handle.3mf with an extra 0.2 mm tolerance to glue the bit insert to the handle a little easier. You may want to start with this one as opposed to the handle piece in the original file.
I picked up a pocket screwdriver kit similar to this at a tradeshow many years ago, and I wanted another one so here it is. The bits fit in snugly and the cover snaps closed.
No supports required (but you might need a brim for the outer case). Print in three pieces then glue the insert and handle together using the alignment nubs. You will also want to glue a tiny magnet in end of the case to hold the bit in place when using the screwdriver.
Disc magnet for the tip should be no larger than 6mm x 1mm – thicker magnets will hold the bits too strong. E.g., https://amzn.com/dp/B01NAL9I5H/
Any straight ¼" / 6mm bits should work, up to ~ 1" / 25mm in length. E.g., https://amzn.com/dp/B09T9H1DFC/
Update:
Added extra-tolerance-handle.3mf with an extra 0.2 mm tolerance to glue the bit insert to the handle a little easier. You may want to start with this one as opposed to the handle piece in the original file.
Mielőtt elmész
Küldd el magadnak
Küldünk egy linket, amivel 7 napig egy kattintással folytathatod – akár a telefonodon is. Ezen az eszközön külön kérés nélkül is megjegyezzük, hol tartasz.
A címedet csak erre az egy levélre használjuk: nem tároljuk, és nem küldünk rá hírlevelet. Adatkezelési tájékoztató